Skip to main content

Wizard Husky 8" Dime Store Fan

Found this fan in a flea market in Branson, Missouri and I could not leave it behind.  The fan did not run when I brought it home. As you can see in the photos below it was dirty with lots of old oil.

This fan was sold by Western Auto stores sometime in the 1950's.  These were cheap made and require lots of oil.  They contain no real bearings and they use no grease just oil on the front and back of the rotor.

Once running this fan moved a uprising amount of air! This fan will remain in it's current state because it has no real value. I will most likely use it daily.



Here is some photos of the motor.




I used some oven cleaner to remove the old oil and gunk. Not a good idea as it will affect the paint, but it did do a great job!





Here is the fan being reassembled!


Back together and running!


Comments

Popular posts from this blog

Bell & Howell Oscilloscope Model 34 DeVry Tech

The Bell & Howell Oscilloscope Model 34 was purchased at an auction and then give to me. It was made by Heathkit for DeVry Tech (DeVry University). Below is a photo of the front after I finished electronically going through it. There was nothing interesting that came up while working on it. Below you can see some before and after of the underside. Below is the top side. The 2 filter cans were 4 sections of 20mfd for a total of eight 20mfd capacitors.  Below is the solution I came up with to replace them. It consists of eight 22 mfd on a PCB that is zipped tied to the bottom of the chassis.   Overall this is a simple oscilloscope and was a simple electronic restore.  Here is the schematic.

O.M.G.S Japanese AA5 Radio

O.M.G.S Japanese AA5 Radio It does work. The electrical work was done prior to me purchasing the radio.

1960 Curtis Mathes Television 1121, 2121, 3121A, 5521A

I purchased this set around Christmas of 2018 for $2.50. As you can see below the socket was broken off of the picture tube. The set was also dirty. Below you can see before and after of the RF section of the TV. Notice all the black capacitors in the first photo. Below is the power supply section. Here is the tv back working again.